4 EDITING FUNCTIONS
160 Outside Erase
4
Set “outside erase”.
1) Press [ON].
2) Adjust the width of the border around the original by pressing either or as required.
When you adjust it to the side, the area to be detected as not belonging to the original is
widened.
When you adjust it to the side, the area to be detected as not belonging to the original is
narrowed.
3) Press [OK].
Do not place any heavy objects (4 kg (9 lb.) or over) on the original glass and do not press on
it with force.
Breaking the glass could injure you.
6
Select other copy modes as required, and then press the [START] button on the control
panel.
5
Place the original on the original glass.
Press [ZOOM] and set the size of the original.
P.76 “Specifying both the original size and the copy paper
size separately”
y When placing the original, be sure that the Original Cover
or the RADF is fully raised. If not, this function may not
properly be able to detect the border between the original
and areas not belonging to it.
y Do not directly look at the original glass during copying
since an intense light may leak.
To Next Page
Loading...
Need help?
General
