2.HOW TO MAKE COPIES
Bypass Copying 49
2 HOW TO MAKE COPIES
y The height of the paper must not exceed the indicator on the side guides.
y When you use more than one sheet of paper, fan the sheets well before placing them on the
bypass tray. Be careful not to cut your fingers when fanning.
y Do not push paper into the entrance of the bypass feeder. This could cause a paper misfeed.
4
Select the same size button under “COPY” as that of the paper you placed on the
bypass tray.
The paper size is now set.
If the paper size is not selected in this step, copying may be slowed down.
5
Press [PAPER TYPE] on the touch panel if the paper type of the paper you placed on
the bypass tray is other than plain paper.
3
Align the side guides to the paper length. Move the
paper holding lever toward the equipment.
When paper is placed, the menu for bypass copying appears.
To Next Page
Loading...
Need help?
General
