Toshiba e-STUDIO 307 - Paper Misfeed in the Bridge Kit (Optional); Paper Misfeed in the Finisher MJ-1107 and the Hole Punch Unit MJ-6104 (both Optional)

1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 29
1 TROUBLESHOOTING FOR THE HARDWARE
 Paper misfeed in the Bridge Kit (optional)
3
Close the Bridge Kit cover.
 Paper misfeed in the Finisher MJ-1107 and the Hole Punch Unit MJ-6104 (both
optional)
Paper misfeed in the upper receiving tray
1
Open the cover holding the handle of the Bridge Kit.
2
Remove the misfed paper inside the Bridge Unit.
If the misfed paper cannot be removed because the right
side is caught by the fuser unit, follow the steps on  P.26
“Paper misfeed in the fuser unit”.
1
Raise the lever and open the upper receiving tray of
the finisher.
2
Remove the misfed paper.
2
1