Toshiba e-STUDIO 307 - Paper Misfeed in the Saddle Stitch Finisher MJ-1108 and the Hole Punch Unit MJ-6104 (both Optional)

1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 33
1 TROUBLESHOOTING FOR THE HARDWARE
9
Close the Bridge Kit cover.
 Paper misfeed in the Saddle Stitch Finisher MJ-1108 and the Hole Punch Unit MJ-6104 (both optional)
10
Close the upper receiving tray of the finisher.
Place your hands on the near and far side of the lever and push
to close the tray until it clicks.
Be careful not to let your fingers be caught between the
finisher body and the upper tray of the finisher.
This could injure you.
The upper receiving tray of the finisher can also be closed by
pressing the right side of the lever.
1
Raise the lever and open the upper receiving tray of
the finisher.
2
Open the cover of the Hole Punch Unit when it is
installed.
2
1