2.TROUBLESHOOTING FOR COPYING
Copying Problems 83
2 TROUBLESHOOTING FOR COPYING
Copied image is partially
missing.
The size or orientation of the
copy paper and that of the
original are not consistent.
The reduction ratio is not
properly set.
Fit the copy paper size to the original or set
the reduction ratio for the copy paper.
The binding margin is too
wide.
Set the binding margin width to fully cover the
original.
For details, refer to Chapter 4 of the Copying
Guide.
The original is larger than the
printable area.
The outside part of the printable area cannot
be copied.
Copied image is blurred. There is a gap between the
original glass and the original.
Lower the Original Cover (optional) or the
Reversing Automatic Document Feeder
(optional) fully so that the original fully
contacts the platen glass.
The copy paper is damp. Replace it with dry copy paper.
Copied image has
unevenness in the
horizontal direction.
The charger is stained. Clean the charger.
P.75 “Cleaning the Charger”
Copied image has black
streaks in the horizontal
direction.
The scanning area or guides
are stained.
Clean them.
P.139 “Regular Maintenance”
The charger is stained. Clean the charger.
P.75 “Cleaning the Charger”
Problem Description Cause Corrective Action
To Next Page
Loading...
