Setting up LDAP Authentication Service 37
1. Set the same time and date as the LDAP Server in the [Administration] -> [Setup] -> [Gen-
eral] page.
2. Set the LDAP Session, DNS Session, and DDNS Session in the [Administration] -> [Setup] -
> [Network] page.
[LDAP Session] Set to Enable.
[DNS Session] Set to Enable and specify the DNS server address.
[DDNS Session] Set to Enable and specify the host name and domain name.
3. Configure the following settings as required.
- The directory service needs to be registered in the [Administration] -> [Maintenance] ->
[Directory Services].
- When you configure the User Authentication for Scan to Email to obtain the From
Address from the directory service, the correct LDAP attribute for “user name” must be
specified. For example, the attribute of “user name” is typically “cn” for Windows 2000
Server and Windows Server 2003, and it is typically “uid” for the Novell Directory Service.
To Next Page
Loading...
