1 TROUBLESHOOTING FOR THE HARDWARE
26 Clearing a Paper Jam
Paper jam in the Saddle Stitch Finisher MJ-1030 and the Hole Punch Unit MJ-6004 (both optional)
When the Hole Punch Unit MJ-6004 is installed
The upper receiving tray of the Finisher can also be closed by
pressing the right side of the lever.
1
Hold up the guide of the paper exit portion and
remove the paper.
When the Hole Punch Unit MJ-6004 is installed, proceed to step 2. If
not, go to step 6.
2
Open the Hole Punch Unit cover.
3
Turn the green knob to locate within the area
indicated on the label.
With the knob set in this position, the punches are up so that paper can
be released.
1
2
To Next Page
Loading...
