1 TROUBLESHOOTING FOR THE HARDWARE
56 Refilling With Staples
8
Close the front cover of the Finisher.
If the message “Check staple cartridge” remains, repeat the procedure above from steps 1 to 8.
4
After the transparent cover is lifted, take out the
empty staple case.
5
Fit the new staple case into the staple cartridge.
Push the staple case into the cartridge until it clicks.
In this step, do not remove the seal bundling the staples.
6
Push the transparent cover down to its original
position, and pull out the seal bundling the staples.
7
Fit the staple cartridge into the stapler.
Insert the staple cartridge until it is caught by the latch and fixed with a
click.
1
2
2
1
To Next Page
Loading...
