e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
1-3
(3) Enter adjustment mode [05]. Change the values for codes [2934 to 2937] to adjust the transfer (2nd
transfer) roller bias output.
(Adjust the offset voltage of transfer roller bias so as to increase the density of the image.)
• The code to use varies according to the paper type. Adjust the value for [05] code corresponding to the
paper type for which you would like to improve the image quality. Set the value within a range of "2" to
"8" to obtain the highest density of the image.
Paper type [05] code Subcode
Recommended
value
Acceptable
value range
Default
Plain paper 0
Thick 1 1
Thick 2 2
Thick 3 3
OHP 4
Special 1 5
Special 2 6
Recycled paper
7
Front
Thick 4
05-2934
8
2 to 8 0 to 10 5
Plain paper 0
Thick 1 1
Thick 2 2
Thick 3 3
OHP 4
Special 1 5
Special 2 6
Recycled paper
7
Full color
Back
Thick 4
05-2935
8
2 to 8 0 to 10 5
Plain paper 0
Thick 1 1
Thick 2 2
Thick 3 3
OHP 4
Special 1 5
Special 2 6
Recycled paper
7
Front
Thick 4
05-2936
8
2 to 8 0 to 10 5
Plain paper 0
Thick 1 1
Thick 2 2
Thick 3 3
OHP 4
Special 1 5
Special 2 6
Recycled paper
7
Black
Back
Thick 4
05-2937
8
2 to 8 0 to 10 5
* "Front" refers to the printed side in the simplex mode or the side that is delivered facing downwards in the duplex
mode.
"Back" refers to the printed side that is delivered facing upwards in the duplex mode.
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
To Next Page
Loading...
