1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 35
1 TROUBLESHOOTING FOR THE HARDWARE
6
Turn the knob shown in the following figures to send the paper, and then remove the
misfed paper.
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same
time.
Some misfed paper may get inside of the Saddle Stitch unit depending on the location where the misfeeding
occurs. In this case, follow step 7.
5
Open the cover of the Hole Punch Unit when it is
installed.
7
Turn the green knob to lower the paper until it is
hidden.
8
Holding the green knob, return the guide to the left.
When the Hole Punch Unit is not installed
When the Hole Punch Unit is installed
To Next Page
Loading...
