1 TROUBLESHOOTING FOR THE HARDWARE
38 Clearing a Paper Misfeed
Clearing paper misfeeds caused by a wrong paper size setting
Paper misfeeds occur when there is a mismatch between the size of the paper in a drawer or the bypass tray and the one
registered for the corresponding drawer or the bypass tray in the equipment. “Check paper size setting on control panel for
drawer N. Check the direction or size of the paper.” or “Check paper size setting on control panel for Bypass. Check the
direction or size of the paper.” appears on the touch panel.
In this case, just clearing the misfed paper does not prevent another paper from being misfed. Be sure to follow the
procedure below.
Troubleshooting differs depending on how the paper misfeed has occurred:
P.39 “Misfeed when making copies or prints (using a drawer)”
P.40 “Misfeed when making copies or prints (using the bypass tray)”
P.41 “Misfeed when printing from the FAX”
19
Return the Saddle Stitch unit to its original position.
20
Close the cover of the Hole Punch Unit when it is
installed.
21
Close the front cover of the finisher.
To Next Page
Loading...
