1 TROUBLESHOOTING FOR THE HARDWARE
58 Refilling With Staples
6
Close the front cover of the finisher.
If the message “Check staple cartridge” remains, repeat the procedure above from steps 1 to 6.
Hanging Finisher MJ-1031
Be careful not to let your fingers be caught between the equipment and the finisher (optional).
This could injure you.
5
Fit the staple cartridge into the stapler.
When fitting the staple cartridge, hold the green-labeled portion of the
bracket securely so that it will not move.
Insert the cartridge until it is caught by the latch and fixed with a click.
1
Separate the finisher from the equipment.
Press the lever to unlock the finisher and slowly separate it from the
equipment, placing your hands on the front and rear of the finisher.
2
Open the staple cartridge unit cover.
To Next Page
Loading...
