e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
6 - 14
6. Printer-specific Adjustments (GA-1211)
Procedures
* Both the service technician and a system administrator can use all the procedures.
(1) Insert the User Software disk to a computer. Then confirm that files “Custom21.ps” and “Custom34.ps” are
stored in the “Windows Color Files\Calibration Files\PS Files” folder.
* These two files are for DTP-32 and DTP32-II. “Custom21.ps” is for a 21-patch chart for A4-R/LT-R, and
“Custom34.ps” is for a 34-patch chart for A3/LD. Do not mix with “Standard21.ps” or “Standard34.ps”.
If a measurement device to be used for calibration is ES-1000 or DTP-41, it is recommended to use an EPS
file in a folder “Windows Color Files\Calibration Files\Halftone Calibration Files\Other Applications” or a
PSD file in a folder “Windows Color Files\Calibration Files\Halftone Calibration Files\Photoshop” in the
User Software disk for confirmation. The EPS file can be downloaded to the hold queue of Command
WorkStation. The PSD file must be printed from Photoshop after setting “None” for the CMYK Simulation
Profile setting of the Expert Settings.
(2) Open the Command WorkStation menu and select as follows: [File] > [Import Job].
To Next Page
Loading...
