e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
6 - 17
6. Printer-specific Adjustments (GA-1211)
(6) The Properties menu of the printer driver appears. Click the [Color] icon from the Print Option, and then click
[Expert Settings]. Then select “None” for [CMYK Simulation Profile] so as not to start simulation.
* Do not mix with the settings for ColorWise Off.
(7) If the media type must be changed, reset the Media Type of the [Media] tab menu. Also be sure to set the size
of media with the “Page Size” setting.
(8) After setting all of the above, print the file “Custom21.ps”.
(9) The test pattern “Custom21.ps” is printed.
(10) Start up the Calibrator, and then click [Measure] of “Get Measurements” to measure the printed pattern.
To Next Page
Loading...
