3 BASIC COPY MODES
66 Selecting Finishing Mode
Selecting Finishing Mode
Finishing modes and optional finishing devices
See the table below for each finishing mode.
The available finishing modes differ depending on the type of optional finishing devices (Finisher, Hole Punch
Unit and Inner Tray) installed. Finishing devices available for this equipment are as follows:
Finisher
Finisher MJ-1107 (for e-STUDIO357/457/507)
Saddle Stitch Finisher MJ-1108 (for e-STUDIO357/457/507)
Inner Finisher MJ-1032N (for e-STUDIO207L/257/307/357/457/507)
Saddle Stitch Finisher MJ-1033 (for e-STUDIO207L/257/307/357/457/507)
Hole Punch Unit
Hole Punch Unit MJ-6104 (for the Finisher MJ-1107 and the Saddle Stitch Finisher MJ-1108)
Hole Punch Unit MJ-6007 (for the Inner Finisher MJ-1032N)
Hole Punch Unit MJ-6008 (for the Saddle Stitch Finisher MJ-1033)
Inner Tray
Job Separator MJ-5004 (for e-STUDIO207L/257/307)
Offset Tray MJ-5005 (for e-STUDIO207L/257/307)
Job Separator MJ-5006 (for e-STUDIO357/457/507)
The Inner Tray cannot be installed if the Inner Finisher MJ-1032N is installed.
Finishing mode Description
Non-sort Non-staple Copies exit without being sorted or stapled.
Sort ( P.71) Copies exit in the same page order as the originals one set after
another.
Group ( P.71) Copies grouped by page exit.
Rotate sort ( P.72) Copies exit set by set alternately in a different direction.
Staple sort ( P.73) Copies exit with their corner stapled.
Magazine sort ( P.75) Copies exit in a book-type page order.
Center fold ( P.75) Copies exit in a book-type page order with their center folded.
Saddle stitch ( P.75) Copies exit in a book-type page order with their center folded and
stapled.
Magazine sort & center fold
( P.7 5 )
Magazine sort and center fold are used together.
Magazine sort & saddle stitch
( P.7 5 )
Magazine sort and saddle stitch are used together.
Hole punch ( P.78) Copies exit with their side punched.
Manual staple ( P.80) Copies are stapled manually.
To Next Page
Loading...
