8.WHEN SOMETHING IS WRONG WITH THE EQUIPMENT
When You Think Something Is Wrong With the Equipment 97
8 WHEN SOMETHING IS WRONG WITH THE EQUIPMENT
Originals and paper
Problem Description Cause Corrective Action
The original is misfed. The original is unavailable on the
equipment.
Check whether the original is available on the equipment.
For details, refer to Chapter 2 of the Copying Guide.
Paper is misfed. The paper is unavailable on the
equipment.
Check whether the paper is available on the equipment.
For details, refer to Chapter 1 of the Copying Guide.
The paper size setting registered for
the equipment is inconsistent with
paper in a drawer or on the bypass
tray.
Match the size of the paper placed in the drawer or on the
bypass tray and the size registered on the equipment.
For Details, refer to Chapter 1 and 2 of the Copying
Guide.
The stack of paper exceeds the
loading line indicated on the side
guide.
Remove some paper to set it within the height limit line
indicated on the side guide.
There is too little or too much
clearance between the paper and the
side guide of the drawer.
Adjust the space between the paper and the side guide or
the end guide not to take much space.
For details, refer to Chapter 1 of the Copying Guide.
Hidden misfed paper has not been
removed.
Check the sign again on the touch panel to see where the
misfeed occurred.
P.13 “Clearing a Paper Misfeed”
Two or more sheets of paper are
fed together.
Sheets of paper are stuck together. Loosen the stack of paper well and set them again.
Sheets do not align when exiting. Sheets are placed in the drawer with
the wrong side up.
Check the printing side of the sheets and place them
correctly. Information about the printing side may be given
on the wrapping paper of the sheets.
If you cannot find which side is the printing side, try
printing on both sides to see if the sheets align when
exiting.
To Next Page
Loading...
Need help?
General
