Toshiba E-Studio 657 - Chapter 2 BASIC OPERATION; Basic Copying Operation; Basic Fax Operation; Basic Scanning Operation

1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 19
1 TROUBLESHOOTING FOR THE HARDWARE
 Paper misfeed in the drawer of the tandem large capacity feeder
 Paper misfeed in the bypass tray
2
Check that the guide width is correct, there is no
folded/curled paper or overloading, and then close
the drawer.
Be sure that the height of the stacked paper does not
exceed the line indicated inside of the side guides.
1
Open the drawer of the tandem large capacity feeder,
and remove the misfed paper.
2
Check that there is no folded/curled paper or
overloading, and then close the drawer of the tandem
large capacity feeder.
Be sure that the height of the stacked paper does not
exceed the line indicated inside of the side guides.
2
1
1
Pull out the paper misfed on the bypass tray and
place it again.
If a sheet of paper is stained, folded or torn, replace it with a
new one.