Toshiba E-Studio 657 - Refilling with Staples; Refilling Finisher MJ-1027; Saddle Stitch Finisher MJ-1028 Staples

1 TROUBLESHOOTING FOR THE HARDWARE
Refilling With Staples 47
Refilling With Staples
Refill with staples according to the following procedures when the staples in the stapler of the finisher and
saddle stitch unit run out.
 P.47 “Refilling Finisher MJ-1027 / Saddle Stitch Finisher MJ-1028 staples”
 P.48 “Refilling Saddle Stitch Finisher MJ-1029 staples”
 P.50 “Refilling saddle stitch unit staples”
 Refilling Finisher MJ-1027 / Saddle Stitch Finisher MJ-1028 staples
1
Open the front cover of the finisher.
2
Lower the lever of the stapler to release the lock, and
then take out the staple cartridge.
3
Take the empty staple case out of the staple cartridge.
4
Fit a new staple case on the staple cartridge.
Push the staple case into the cartridge until it clicks.
In this step, do not remove the seal bundling the staples.
2
1