Toshiba E-Studio 657 - Setting Universal Printer 2 Driver; Paper Size and Copy Sets; Finishing Options

1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 33
1 TROUBLESHOOTING FOR THE HARDWARE
 Misfeed when making copies or prints (using the bypass tray)
1
Clear the paper misfeed following the guidance shown on the touch panel. Then close
all the covers.
2
Press [YES] when “Cancel print job?” appears.
The print job is canceled.
If you do not want to cancel the print job
To restart the job without canceling it, replace the paper on the bypass tray with that corresponding to
the size set in the equipment after the paper misfeed is cleared. Then if you press [NO] in step 2, the
job can be restarted. In this case, it is not necessary to follow step 3 and later.
3
Place the paper on the bypass tray and set the paper size.
4
Try copying or printing again.
 Misfeed when printing from the FAX
1
Pull out the drawer in which paper misfeeds occurred
and remove all the paper from it.
2
Place the paper corresponding to the set size in the
drawer.