1 TROUBLESHOOTING FOR THE HARDWARE
50 Refilling With Staples
8
Close the front cover of the finisher.
If the message “Check staple cartridge” remains, repeat the procedure above from steps 1 to 8.
Refilling saddle stitch unit staples
When the staples of the saddle stitch unit stapler in the Saddle Stitch Finisher have run out, refill them
following the procedure below.
1
Open the lower front cover of the finisher.
2
Slowly pull out the saddle stitch unit.
3
Unlock the stapler of the saddle stitch unit by pulling
its handle toward you. Keep pulling the handle, and
turn the stapler clockwise by about 60 degrees.
The stapler is locked and cannot be turned any further when it
lies almost horizontally.
4
Remove the staple cartridges.
Replace both cartridges at a time.
To Next Page
Loading...
