1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Staple Jam 39
1 TROUBLESHOOTING FOR THE HARDWARE
11
Make sure of the following two requirements before test stapling:
The Saddle Stitch Finisher is securely attached to the equipment.
A3, B4, A4-R, LD, or LT-R paper is set in the drawer.
6
Remove the jammed staples.
7
Push the knob to lower the shutter.
Check that the shutter is securely held by the latch of the green
lever.
8
Fit the staple cartridge.
Insert each cartridge until it is fixed with a click.
9
Unlock the stapler by pulling its handle toward you.
Then return the stapler to its original position.
10
Carefully insert the saddle stitch unit into the finisher.
To Next Page
Loading...
