7 TopAccess Administrator Mode
130 Setting up from TopAccess
yWhen “Verify with imported cert” is selected, you must import the CA certificate in this
equipment.
P.145 “Setting up the Security Service”
yIf at least one of the registered LDAP directory services requires the SSL, you must enable
the “Enable SSL” option. When the “Enable SSL” option is enabled, this equipment will
connect the registered LDAP directory services using SSL first. Then if the connection
fails using SSL, this will connect to the registered LDAP directory service without using
SSL. Therefore, even if you enable the “Enable SSL” option, this equipment can also
connect to the LDAP directory service that the SSL is not required.
yThe SSL port number can be set for each LDAP directory service when it is registered.
P.203 “Managing Directory Service”
yNot all operating systems support SSL for all protocols.
Setting up the DNS Session
In DNS Session, you can specify the DNS server to enable the FQDN (Fully Qualified Domain
Name) rather than the IP address on specifying each server address such as SMTP server,
POP3 server, and LDAP server.
When the DNS service is enabled and the DNS server supports the dynamic DNS service,
please set the DDNS Session as well.
P.131 “Setting up the DDNS Session”
1) Enable DNS
Select whether the DNS server is used or not.
2) Primary DNS Server Address
Specify the IP address of the primary DNS server when the DNS service is enabled.
3) Secondary DNS Server Address
Specify the IP address of the secondary DNS server when the DNS service is enabled, as
you require.
4) Primary DNS Server Address(IPv6)
Specify the IP address of the primary DNS server when the DNS service is enabled in IPv6.
5) Secondary DNS Server Address(IPv6)
Specify the IP address of the secondary DNS server when the DNS service is enabled in
IPv6, as required.
1
2
3
4
5
To Next Page
Loading...
