Setting up User Management 265
7
Enter domain names for the network in the Domain Name 1, Domain
Name 2 and Domain Name 3 fields, and then click [Detail Setting].
You can specify up to 3 domain names. You must specify at least one domain name to
enable the Windows Domain Authentication.
8
Click [NT Domain], and Enter the following items. Then click [Next].
Domain Name — The domain name entered in Step 7 is displayed.
PDC — Enter the server name or IP address of the Primary Domain Controller.
BDC — Enter the server name or IP address of the Backup Domain Controller as you
required.
If the wrong primary or backup domain controller is specified, the [ENTER] button in the
USER AUTHENTICATION screen on the touch panel is highlighted while this equipment
searches for the primary or backup domain controller for 2 to 4 minutes. In that case,
correct the primary or backup domain controller setting after the beep will sound and the
alert message will be displayed on the touch panel.
To Next Page
Loading...
