SETUP FLOW FOR PRINTING FEATURES 53
Set up the IPv6 Assign the IP address, prefix, Gateway address.
Reference: USER FUNCTIONS GUIDE
y Chapter 4 “SETTING ITEMS (ADMIN)”
“3. SETTING NETWORK FUNCTIONS”
“Setting the TCP/IP Protocol (IPv6)”
Reference: TopAccess Guide
y Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Network Settings”
“Setting up the IPv6”
Set up the Printing Ser-
vice
Enable the Raw TCP or LPD Printing Service using TopAccess.
Reference: TopAccess Guide
y Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Print Service Settings”
“Setting up the Raw TCP Print”
“Setting up the LPD Print”
Install the Printer Driver
on the Windows Print
Server
Install the printer driver from the Client Utilities CD-ROM.
Reference: Printing Guide
y Chapter 2 “INSTALLING CLIENT SOFTWARE FOR WINDOWS”
“Installing the Client Software for Raw TCP/LPR Printing”
Configuring the Printer
Drivers
Configure the options and department code.
Reference: Printing Guide
y Chapter 5 “PRINTING FROM WINDOWS”
“Before Using the Printer Driver”
Setting up the Print
Server
Configure the printer on the Windows print server as shared printer.
Reference: Network Administration Guide
y Chapter 1 “SETTING UP NETWORK SERVER”
“Setting up Windows Print Server”
Install the Printer Driver
on the Client computers
Install the printer driver from the queue in the Windows print server by point
and print installation. This installation method is common for Windows print
sharing service. Please refer to the Windows documentation about the
installation from the Windows shared printer.
Setup Flow Description/Reference
To Next Page
Loading...
