Toshiba e-STUDIO233 - Setup Flow for Lpr Printing

5 SETUP FLOW
58 SETUP FLOW FOR PRINTING FEATURES
Setup Flow for LPR Printing
This equipment can be used with LPR printer connection using the LaserWriter 8 printer driver.
Setup Flow Description/Reference
Connect this equipment Connect the machine to your network with a network cable.
Reference: QUICK START GUIDE
y Chapter 4 “CONNECTING TO THE DEVICE”
“2. CONNECTING TO THE NETWORK”
Set up the TCP/IP (IPv4) Assign the IP address, Subnet mask, Gateway address.
Reference: USER FUNCTIONS GUIDE
y Chapter 4 “SETTING ITEMS (ADMIN)”
“3. SETTING NETWORK FUNCTIONS”
“Setting the TCP/IP Protocol (IPv4)”
Reference: TopAccess Guide
y Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Network Settings”
“Setting up the TCP/IP”
Set up the IPv6 Assign the IP address, prefix, Gateway address.
Reference: USER FUNCTIONS GUIDE
y Chapter 4 “SETTING ITEMS (ADMIN)”
“3. SETTING NETWORK FUNCTIONS”
“Setting the TCP/IP Protocol (IPv6)”
Reference: TopAccess Guide
y Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Network Settings”
“Setting up the IPv6”
Set up the Printing Ser-
vice
Enable the LPD Printing Service using TopAccess.
Reference: TopAccess Guide
y Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Print Service Settings”
“Setting up the LPD Print”
Mac OS 8.6
Mac OS 9.x
Mac OS X
Connecting over TCP/IP Network
Setting up the LPR
printer connection

Ð

Ð
Ð

Ð

Ð
Ð

Ð
Ð
