SETUP FLOW FOR PRINTING FEATURES 63
Setup Flow Description/Reference
Connect this equipment Connect the machine to your network with a network cable.
Reference: QUICK START GUIDE
y Chapter 4 “CONNECTING TO THE DEVICE”
“2. CONNECTING TO THE NETWORK”
Set up the TCP/IP (IPv4) Assign the IP address, Subnet mask, Gateway address.
Reference: USER FUNCTIONS GUIDE
y Chapter 4 “SETTING ITEMS (ADMIN)”
“3. SETTING NETWORK FUNCTIONS”
“Setting the TCP/IP Protocol (IPv4)”
Reference: TopAccess Guide
y Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Network Settings”
“Setting up the TCP/IP”
Set up the IPv6 Assign the IP address, prefix, Gateway address.
Reference: USER FUNCTIONS GUIDE
y Chapter 4 “SETTING ITEMS (ADMIN)”
“3. SETTING NETWORK FUNCTIONS”
“Setting the TCP/IP Protocol (IPv6)”
Reference: TopAccess Guide
y Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Network Settings”
“Setting up the IPv6”
Set up the Printing Ser-
vice
Enable the LPD Printing Service using TopAccess.
Reference: TopAccess Guide
y Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Print Service Settings”
“Setting up the LPD Print”
Install the Client Software Install the UNIX filters from the Client Utilities CD-ROM and configure a print
queue.
Reference: Printing Guide
y Chapter 4 “INSTALLING CLIENT SOFTWARE FOR UNIX”
“Setting Up the UNIX Filters”
To Next Page
Loading...
