Chapter 1 PREPARATIONS
14
Conguration of options
1. Original Cover (KA-3511PC)
This is used to hold an original.
2.
Reversing Automatic Document Feeder (MR-3018)
This unit automatically feeds a stack of originals one by
one to have them copied.
3. Bridge Unit (KN-4520)
This unit acts as a relay for the Finisher and this
equipment.
4. Paper Feed Pedestal (KD-1023)
This pedestal enables you to install the Additional Drawer
Module (optional, MY-1032).
5. Large Capacity Feeder (KD-1024)
This feeder enables you to feed up to 2500 sheets (80 g/m
2
or 20 lb. Bond) or 2000 sheets (90 g/m
2
or 28 lb. Bond) of
A4 or LT paper.
6. Additional Drawer Module (MY-1032)
This drawer can be added to the Paper Feed Pedestal
(optional, KD-1023). Combined with the 2 drawers in the
equipment, paper can be fed from 4 drawers in total.
7. Finisher (MJ-1101)
This Finisher enables sort/group nishing and stapling.
The Hole Punch Unit (optional, MJ-6101) can be installed
in this Finisher. The Bridge Unit (optional, KN-4520) is
required for the installation of this Finisher.
8. Saddle Stitch Finisher (MJ-1030)
This Finisher enables saddle stitching, in addition to sort/
group nishing and stapling. The Hole Punch Unit
(optional
, MJ-6004) can be installed in this Finisher. The
Bridge Unit (optional, KN-4520) is required for the
installation of this Finisher.
9. Hanging Finisher (MJ-1031)
This Finisher enables sort/group nishing and stapling.
The Bridge Unit (optional, KN-4520) is required for the
installation of this Finisher.
10. Hole Punch Unit (MJ-6101)
This unit enables you to punch holes on printed sheets.
Install it in the Finisher (optional, MJ-1101) to use it.
11. Hole Punch Unit (MJ-6004)
This unit enables you to punch holes on printed sheets.
Install it in the Finisher (optional, MJ-1030) to use it.
To Next Page
Loading...
Need help?
General
