Chapter 1 PREPARATIONS
18
Adjustment of the angle of the control panel
Adjusting the angle of the control panel
The angle of the control panel is adjustable at any angle between 7
and 52 degrees from the horizontal position.
Fixing the angle of the control panel
The angle of the control panel can be xed with the stopper on the
backside of the control panel (at 7 degrees from the horizontal
position). The stopper is located in position A when the equipment is
set up. Move it from position A to B before xing it.
CAUTION
When changing the angle of the control panel, be careful not to catch your hands in the gap between the equipment and
the control panel.
This could injure you.
A: The position where the angle is adjustable.
B: The position where the angle is xed.
To Next Page
Loading...
Need help?
General
