Toshiba e-STUDIO3015AC - To Program Frequently Used Copy Settings (to Use Custom Mode); To Adjust User Custom Mode Settings in Black Mode

To Next Page

To Previous Page

2.Copier-specific Adjustments

2-80

2.19 To Program Frequently Used Copy Settings (To use

Custom Mode)

 Explanation

Five original modes (Text/Photo, Text, Printed Image, Photo and Map) are available for the color modes

and four original modes (Text/Photo, Text, Photo and Image Smoothing) are available for the black mode

by default. However, a new original mode adjusted to be able to satisfy the user’s particular requests

about image quality can be added as a “User Custom” mode. One custom mode can be added for each

of the color and black modes. For users who frequently use the special type of originals or who are not

satisfied with the image quality of the existing original modes, it is recommended to register a set of copy

settings that satisfy the user’s particular requests as the User Custom mode. However, “Photo” and

“Image Smoothing” cannot be selected for the “User Custom” mode.

• In the User Custom mode, one of the original modes set by default is selected as a base (reference)

original mode. Adjustments required for the intended purpose must be performed based on the

selected mode.

It is also available to use the User Custom mode as an independent original mode. This means that

the change of the setting values in the User Custom mode does not affect each default original modes.

 Procedures

The adjustment procedure differs depending on whether in the black mode or the full color mode the

settings in the User Custom mode are adjusted. Refer to the procedure corresponding to the user’s

particular request.

2.19.1 To Adjust User Custom Mode Settings in Black Mode

• Perform the adjustment in accordance with the procedures below.

• Only the service technician must perform procedures (1) and (2).

• Both the service technician and the user perform use procedure (3).

(1) Select [08 SETTING MODE]. Change the value for the code [7034] to enable the functions of the

User Custom mode in the black mode.

After setting the value, perform the next procedure.

Value for 08-7034 User Custom mode for black mode

0 Unused

1 Used (Text/Photo base)

2 Used (Text base)

Other manuals for Toshiba e-STUDIO3015AC