2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-100
• The setting content of the default value “0” is the same as that for the setting value of each original
mode as below.
Caution after the adjustment
This adjustment will affect to that for set at (3) in "2.12.1 To Adjust the Copy Image Quality of a Black
Logo". When performing this adjustment, pay attention to the balance against the reproduction level of
the black color logos, too.
Original mode Setting value Original mode Setting value
Text/Photo 3 Printed Image
3Tex t 4 Ph ot o
Red Seal Color 3 Map
To Next Page
Loading...
