Toshiba e-STUDIO3015AC - Page 156

2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-102
 Caution after the adjustment
When “1” is set, color objects sometimes appear in black text or black lines may be cut. Therefore, the
setting change to give priority should be performed while images are checked.
When sufficient effectiveness has not been obtained for Text/Photo mode and User Custom mode for
Text/Photo by means of procedure (1) only, perform procedure (2), too.
(2) Select [05 ADJUSTMENT MODE]. Change the values for the following codes below to adjust the
density level of the color text.
Original
mode
Color to
adjust
Subcode Area where
the density is adjusted
Default Recommended value
Text/Photo
Y (Yellow)
Low density 128
When a larger value is set,
fine lines and thin text
become darker. When a
smaller value is set, they
become lighter.
Middle density 128
High density 128
M (Magenta)
Low density 128
Middle density 128
High density 128
C (Cyan)
Low density 128
Middle density 128
High density 128
K (Black)
Low density 128
Middle density 128
High density 128
User Custom
Y (Yellow)
Low density 128
Middle density 128
High density 128
M (Magenta)
Low density 128
Middle density 128
High density 128
C (Cyan)
Low density 128
Middle density 128
High density 128
K (Black)
Low density 128
Middle density 128
High density 128