1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
1-11
(b) Perform automatic calibration.
• Be sure to perform automatic calibration not only with the paper types adjusted in step (1)
and (2), but also all paper types. Refer to the following table for adjustment.
• After replacing any consumable, remember to reset the counter corresponding to it to “0”.
Otherwise, it may cause a loss in MFP performance, including degradation in the image quality
and a reduction in the life of the consumables.
Caution after the adjustment
• The adjustment may possibly cause an increase in the amount of toner consumed, scattering of the
toner, diminished photo images or gradations (less accurate reproducibility of halftones), extremely
dark images (decreased resolving power), extremely light images (faint thin lines), and shorten the life
of the consumables. Therefore, carefully perform the adjustment, while checking the copy or print
image.
• No effect of the adjustment may appear, depending on the installation environment of the MFP.
Therefore, carefully perform the adjustment, while checking the copy or print image.
Remarks
• The effect of the adjustment may vary, depending on the usage pattern of the consumables, such as
the developer material and drum, and the installation environment of the MFP.
• When replacing any consumable, refer to the relevant information in the Service Manual.
Print mode How to perform automatic calibration
Copy
Perform step (1) referring to "2.14 To Obtain a Good Color
Balance on Thick Paper". Perform step (2) and later if required.
Printer
(600 dpi)
Perform step (2) referring to "3.3.2 To Maintain a Steady Color
Balance on Thick Paper or Special Paper".
Printer
(1200 dpi)
To Next Page
Loading...
