2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-25
(5) Select [05 ADJUSTMENT MODE] and arrange the color balance by changing the setting values for
the codes from [7960] to [7987] to adjust the density for each color.
• Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
• The value for the code corresponding to the original mode (Text/Photo, Text, or Printed Image) will
affect the copy image quality in the Full color mode and the Auto Color mode.
• The setting value “25” corresponds to one step in the adjustment on the control panel.
Subcode Target area of hue adjustment Recommended value
0 For adjusting the tint of Red
Setting a larger value: The saturation level
increases.
Setting a smaller value: The saturation level
decreases.
1 For adjusting the tint of Yellow
2 For adjusting the tint of Green
3 For adjusting the tint of Cyan
4 For adjusting the tint of Blue
5 For adjusting the tint of Magenta
Color to adjust Original mode [05] code Subcode
Recommended
value
Acceptable
value range
Default
Text/Photo
Y (Yellow) 05-7960
0 / 1 / 2
Set a value larger
than 128 to increase
the density.
Set a value smaller
than 128 to decrease
the density.
0 to 255 128
M (Magenta) 05-7965
C (Cyan) 05-7970
K (Black) 05-7975
Tex t
Y (Yellow) 05-7961
M (Magenta) 05-7966
C (Cyan) 05-7971
K (Black) 05-7976
Printed Image
Y (Yellow) 05-7962
M (Magenta) 05-7967
C (Cyan) 05-7972
K (Black) 05-7977
Photo
Y (Yellow) 05-7963
M (Magenta) 05-7968
C (Cyan) 05-7973
K (Black) 05-7978
Map
Y (Yellow) 05-7964
M (Magenta) 05-7969
C (Cyan) 05-7974
K (Black) 05-7979
User Custom
Y (Yellow) 05-7980
M (Magenta) 05-7981
C (Cyan) 05-7982
K (Black) 05-7983
Red Seal Color
Y (Yellow) 05-7984
M (Magenta) 05-7985
C (Cyan) 05-7986
K (Black) 05-7987
To Next Page
Loading...
