2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-37
After adjusting the background density, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(5) Press [Basic] tab on the Copy mode. Select “Text” from among the original mode options.
• To have “Text” selected from among the original mode options by default, perform the following
setting.
Press [User Functions -User-] and select [Copy] in the [User] tab. Select [Text] in the “Original
Mode for Color” option.
Caution after the adjustment
The adjustment may possibly cause the highlighted area to become less visible on the copy. Therefore,
carefully perform the adjustment, while checking the copy image.
Remarks
Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may
cause a loss in MFP performance, including degradation in the image quality.
To Next Page
Loading...
