Toshiba E-STUDIO3505AC - Chapter 4 Fax Functions

Clearing a Paper Misfeed 19
TROUBLESHOOTING FOR THE HARDWARE
0.Clearing a Paper Misfeed
 Locating a paper misfeed
The equipment stops copying when the original or copy paper is misfed. Paper misfeeds are notified on the touch
panel as follows:
The paper misfeed symbol helps you locate the paper misfeed.
1. RADF or DSDF (lower) ( P.22)
2. RADF or DSDF (upper) ( P.22)
3. Job Separator, Offset Tray ( P.41) or Bridge Kit ( P.42)
4. Fuser unit ( P.36)
5. Automatic duplexing unit ( P.34)
6. Bypass tray ( P.33)
7. Drawer feeding portion ( P.28)
8. Large Capacity Feeder ( P.29) or Paper Feed Pedestal ( P.29)
9. Paper transport path ( P.35)
10. Drawers ( P.30,  P.31), Envelope Drawer ( P.32) or drawer of the Large Capacity Feeder ( P.32)
11. Saddle stitch unit ( P.51)
12. Finisher ( P.42,  P.48,  P.57)
13. Hole Punch Unit ( P.42, P.48, P.57)
The picture of the hardware device shown on the touch panel differs depending on the options installed.
Error code
Error message
Paper misfeed symbols
Guidance for
clearing paper misfeeds
1113 12
1
9 78
2 3 4 5 6
10