1.TROUBLESHOOTING FOR THE HARDWARE
64 Clearing a Paper Misfeed
2
Press [Yes] when “Cancel print job?” appears.
The print job is canceled.
If you do not want to cancel the print job
To restart the job without canceling it, replace the paper on the bypass tray with that corresponding to the size
set in the equipment after the paper misfeed is cleared. Then if you press [No] in step 2, the job can be restarted.
In this case, it is not necessary to follow step 3 and later.
3
Place the paper on the bypass tray and set the paper size.
4
Try copying or printing again.
Misfeed when printing from the Fax
1
Pull out the drawer in which paper misfeeds occurred and remove all the paper from it.
If such paper misfeeds occur although [Auto (mm)] or [Auto (inch)] has been selected as the paper size, this is
caused by the incorrect size detection of the paper placed in the drawer. In this case, do not remove the paper
and proceed to step 3.
2
Place the paper corresponding to the set size in the drawer.
3
Check that the guide width is correct and there is no folded/curled paper or overloading, and
then close the drawer.
To Next Page
Loading...
