Toshiba e-STUDIO353 - Construction

6
6 - 2e-STUDIO350/352/353/450/452/453
SCANNER
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
6.2 Construction
a. Exposure lamp
This lamp is the light source to irradiate the original on the glass. (One 16W xenon lamp)
b. Lamp inverter
Controls lighting of the xenon lamp.
c. Reector
 Thisisaplatetoefcientlydirectthelightfromtheexposurelamptothesurfaceoftheoriginal
on the glass.
d. Mirror-1
 Thismirrordirectsthelightreectedfromtheoriginaltothemirror-2describedlater.
Fig. 6-202
Fig. 6-201
The following shows the construction and purpose of the scanning system:
(1) Original glass
This is a glass on which original is placed. The light from the exposure lamp is irradiated to the
original through this glass.
(2) Carriage-1
 Carriage-1consistsoftheexposurelamp,lampinverters,reector,mirror-1,etc.Itisdrivenby
the scan motor and scans an original on the glass.
Reector
Lamp inverter
Exposure lamp
Mirror-1
Original glass
Original
Exposure lamp
Lamp inverter
Reector
Mirror-1