9 - 10
9
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 9-401
Fig. 9-402
Fig. 9-403
Fig. 9-404
9.4 Disassembly and Replacement
[A] Bypass unit
(A-1) Bypass unit
(1) Remove the upper/lower drawer.
(2) Remove 2 screws and take off the right front
hinge cover.
(3) Remove 2 screws and take off the right rear
hinge cover.
(4) Remove 2 screws and take off the right
lower cover.
(5) Remove 1 screw and take off the 2 ground
wires.
(6) Disconnect 1 connector and release the
harness from harness clamp.
Right front hinge cover
Screw
Screw
Right rear hinge cover
Screw
Right lower cover
Screw
Ground wire
Connector
To Next Page
Loading...
