e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
9
9 - 11
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
(7) Open the side cover.
(8) Remove 2 screws, lift the bypass unit up,
remove 2 hooks and pull it out to the front.
(A-2) Hinge assembly
(1)
Take off the bypass unit ( Chapter 9.4 (A-1)).
(2) Disconnect 1 connector and release the har-
ness from harness clamp.
(3) Remove 2 screws and slide the hinge as-
sembly to take it off with the tray. (Standing
the tray makes easier to be removed.)
Fig. 9-405
Fig. 9-406
Fig. 9-407
Fig. 9-408
Side cover
Screw
Screw
Bypass unit
Screw
To Next Page
Loading...
