Toshiba e-STUDIO353

To Next Page

To Previous Page

e-STUDIO350/352/353/450/452/453

PAPER FEEDING SYSTEM

9 - 17

(A-11) Bypass feed sensor

(1)

Take off the bypass unit ( Chapter 9.4 (A-1)).

(2) Take off the lower plate ( Chapter 9.4

(A-10)).

(3) Remove 1 screw and take off the sensor

plate.

(4) Disconnect 1 connector, release the latch to

take off the bypass feed sensor.

Note:

Be careful not to come off the sensor arm

and the sensor spring after taking off the

sensor.

Fig. 9-431

Fig. 9-430

Sensor plate

Screw

Sensor Spring

Sensor arm

Bypass feed sensor

(4) Detach the cover, the arbor, and the clutch

spring from the shaft, and then take off the

bypass separation roller.

Fig. 9-429

Bypass separation

roller assembly

(3) Take off the bypass separation roller assem-

bly.

Fig. 9-428

Shaft

Bypass separation roller

Cover

Clutch

spring

Arbor

Toshiba e-STUDIO353 - Page 183