e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-75
2. Copier-specific Adjustments
(2) Select [05 ADJUSTMENT MODE]. Change the values for codes [7024] or [7025] or [7026] to adjust the
reproducibility of the background when using the DF.
Color mode Original mode [05] code Recommended value
Default
Full color for
front side for
DSDF
ALL 05-7026
Set a value larger than 128 to
increase the background
density.
Set a value smaller than 128
to decrease the background
density.
0 to 255 128
Black for front
side for DSDF
ALL 05-7025
full color and
black back side
ALL 05-7024
* Set the value in increments of approximately 20, while checking the copy image until the optimum value is
obtained.
* Note that the adjustment results are also reflected to the scanning function.
Caution after the adjustment
Correctly adjusting the installation heights of the MFP and the DF is a prerequisite to perform this adjustment.
Therefore, perform all the necessary adjustments. Only if further adjustment is still desired for the reproducibility of
background, should this adjustment be performed.
To Next Page
Loading...
