Toshiba E-STUDIO6506AC - To Suppress Color Misalignment

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-143
3. Printer-specific Adjustments
3.28 To Suppress Color Misalignment

Explanation
White voids in the background caused by off-registration of the text or graphics can be reduced and color
misalignment can be suppressed by the Auto Trapping adjustment. Use this mode if the effectiveness of the color
misalignment correction is to be enhanced.

Procedures
* The service technician must perform all adjustments.
Enter [05 ADJUSTMENT MODE] and change the setting value for the code [8244]. First, change the setting
value of the subcode “0”. Only when the effect is insufficient even if the setting value of the subcode “0” is
changed to “3”, alter the one for the subcode “1”.
Color mode Adjustment
[05]
Code
Subcode
Recommended
value
Acceptable
value range
Default
Auto/Color
Trap width (dot) 8244 0
Set the value to 3
(*1)
1 to 3 2
Trap density 8244 1
Set the value
smaller than 128
(*2)
0 to 255 128
*1 When a larger value is set, it will get stronger against a wider gap (off-registration); however, overlapped
areas will become more conspicuous.
*2 The smaller the value is, the darker the color becomes. In this case, the gaps will not become conspicuous;
however, overlapped areas will become more conspicuous.

Caution after the adjustment
Perform the adjustment while checking the images, since the outline form of the boundary of the text or graphics
will be accentuated if the effectiveness of the trapping is enhanced.

Remarks
Nothing
Before adjustment
After adjustment