Toshiba E-STUDIO6506AC - Page 178

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-42
3. Printer-specific Adjustments
(2) Select [05 ADJUSTMENT MODE]. Decrease the setting values for codes [8108] to [8113] and [8118] to
adjust the sharpness to be decreased.
• Adjust the [05] code for the settings (color mode and original type) to be used for printing.
Color
mode
Original
mode
[05]
code
Subcode
Recommended
value
Acceptable
value
range
Default
Auto/Color
General
05-8110
0/1/2
Set a value
smaller than 128.
0 to 255 128
Photo
05-8111
0/1/2
Presentation
05-8112
0/1/2
Line art
05-8113
0/1/2
Mono
color
- 05-8118 0/1/2
Twin color
-
05-8108
0/1/2
Auto/Color
Red seal color
05-8109
0/1/2
Subcode
Original
0
Text
1
Graphics
2
Image
<Note>
•When the setting value of this code is larger than "128" (default), the level of the sharpness
intensity is equivalent to the one when the value is set within a range of "0" to "+4" on the printer
driver menu. When the setting value of this code is smaller than "128", the level of the sharpness
intensity is equivalent to the one when the value is set within a range of "-4" to "-1" on the
printer driver menu. Note that when the setting value of this code is "-1", the image quality will
not be changed even if the value is changed on the printer driver menu.

Caution after the adjustment
The adjustment provides a soft or blurred image in general. Therefore, carefully perform the adjustment, while
checking the printouts. Especially text and lines on the background of a gradational image, and text in the
Format AutoShape dialog box with transparency selected on Microsoft Office may be blurred.