Toshiba E-STUDIO6506AC - Page 287

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-151
3. Printer-specific Adjustments
(i) By referring to the table below, change the setting value (reduction rate).
Relationship between the amount of the deviation and the setting value (E.g.: A4/LT landscape)
Setting value
Long edge
Short edge
A4 (mm)
LT (inch)
A4 (mm)
LT (inch)
0: Not adjusted
-
-
-
-
1: 0.05% reduction
0.150
0.055
0.110
0.043
2: 0.10% reduction
0.300
0.110
0.210
0.085
3: 0.15% reduction
0.450
0.165
0.320
0.128
4: 0.20% reduction
0.590
0.220
0.420
0.170
5: 0.25% reduction
0.740
0.275
0.530
0.213
6: 0.30% reduction
0.890
0.330
0.630
0.255
7: 0.35% reduction
1.040
0.385
0.740
0.298
8: 0.40% reduction
1.190
0.440
0.840
0.340
9: 0.45% reduction
1.340
0.495
0.950
0.383
10: 0.50% reduction
1.490
0.550
1.050
0.425
(j) If the result of the adjustment is insufficient, repeat steps (f) to (i).
Tips:
When you let a user perform this adjustment, set "1" in 08-3514 and display the setting screen of this adjustment
in TopView.
Setting value of
08-3514
Screen display of reproduction ratio adjustment at duplex
printing on TopAccess
0
Not display (default)
1
Display
Check that [Adjustment Position in Duplex Print (reduction ratio)] is displayed in TopAccess - [Administration] -
[Printer].
* The setting procedure is the same as that for (4).