Toshiba E-STUDIO6506AC - Printer and e-Filing Configuration

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-3
2. Copier-specific Adjustments
(4) Select [05 ADJUSTMENT MODE]. Increase the values for codes [7056] to [7058] and [7061], [7249] to
make the copied text darker (sharpness level increases).
• The code to use varies according to the original mode (Text/Photo, Text or Photo). Adjust the value for
[05] code corresponding to the original mode in which you would like to improve the image quality and set
values larger than “128”.
Color mode Original mode [05]code
Recommended
value
Acceptable
value range
Default
Black
Text/Photo
05-7056
Set a value larger
than 128.
0 to 255 128
Text
05-7057
Photo
05-7058
Image smoothing
05-7061
User custom
05-7249
* The smaller the setting value, the lower the sharpness becomes, while the larger the setting value, the
higher the sharpness becomes.
(For example, if the intensity of the center value is reduced by "25" (smaller), the value of each step of the
indicator will also be correspondingly decreased.) However, the adjustment value range which affects the
sharpness is within +/-100; this is the total of the setting value for the [05] code and that for the indicator.
For example, when "103" (reduced by 25 from the default value) is set for the [05] code as shown in the
figure below, the variation on the software side by the indicator is within -3 steps. Even if -4 steps are
applied, the image quality will not change.
After selecting the Text mode, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
Since "
-25" is assigned to the center, the image quality
remains the same even if the indicator is changed from
"
-3" to "-4".
Setting value "103":
Default:
Soft
Sharp
+3
+50
+75
|
+1
0
+25
|
0
-25
0
|
-2
-75
-50
|
-4
-100
-100
|
+4
+75
+100
|
+2
+25
+50
|
-1
-50
-25
|
-3
-100
-75
|
Assigned adjustment
value of sharpness