e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-26
2. Copier-specific Adjustments
(5) Select [05 ADJUSTMENT MODE]. Change the values for codes [7190 to 7193] and [7960 to 7987] to
adjust the color density.
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
* The value for the code corresponding to the original mode (Text/Photo, Text, or Printed image) will affect
the copy image quality in the Full color mode and the Auto color mode.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set the
subcode for the area to be adjusted. The density of the highlighted area will vary, if the low- or medium-
density area is mainly adjusted. Setting “2” for subcode allows you to adjust the high-density area. But it
will not affect the highlighted area. Therefore, never change the value for the high-density area.
To Next Page
Loading...
