e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-38
2. Copier-specific Adjustments
(3) Press [BASIC] on the Control Panel. Select “TEXT” from among the original mode options.
* To have “TEXT” selected from among the original mode options by default, refer to 2.18 To Program
Frequently Used Copy Settings (To Use Custom Mode).
Caution after the adjustment
The adjustment may possibly cause the highlighted area to become less visible on the copy. Therefore, carefully
perform the adjustment, while checking the copy image.
Remarks
Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may cause a loss
in MFP performance, including degradation in the image quality.
To Next Page
Loading...
