Toshiba E-STUDIO6506AC - System Requirements for Installation

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-50
2. Copier-specific Adjustments
* For the User custom mode, refer to "2.18 To Program Frequently Used Copy Settings (To Use Custom
Mode)".

Caution after the adjustment
When an original containing text is copied, the adjustment may possibly cause the text to become blurred on the
copy. Therefore, carefully perform the adjustment, while checking the copy image.

Remarks
Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may cause a loss
in MFP performance, including degradation in the image quality.
Value
Advantage of image quality
Reproducibility of edges
0
Default
Intermediate
1
Intended to improve the reproducibility of photos more
than the one obtained when “2” is set.
Soft
2
Intended to improve the reproducibility of photos more
than the one obtained when “3” is set.
↓
3
Intended to improve the reproducibility of photos more
than the one obtained when “4” is set.
↓
4
Intended to improve the reproducibility of photos more
than the one obtained when “5” is set.
↓
5
Equivalent to the one obtained when the default value
(“0”) is set.
Intermediate
6
Intended to improve the reproducibility of text more
than the one obtained when “5” is set.
↓
7
Intended to improve the reproducibility of text more
than the one obtained when “6” is set.
↓
8
Intended to improve the reproducibility of text more
than the one obtained when “7” is set.
↓
9
Intended to improve the reproducibility of text more
than the one obtained when “8” is set.
Sharp