2 SETTING ITEMS (ADMIN)
156 Setting Network Functions
3
Specify the following items as required and press [OK].
ENABLE HTTP SERVER — Press [ENABLE] to enable the HTTP network server service, or [DISABLE] to disable
the HTTP network server service. This option must be enabled for TopAccess and the e-Filing web utility.
ENABLE SSL — Press [ENABLE] to enable the SSL for accessing TopAccess and the e-Filing web utility, or
[DISABLE] to disable the SSL for accessing TopAccess and the e-Filing web utility. When this option is enabled,
the data transferred between the equipment and client computers will be encrypted using a private key when
operating TopAccess and the e-Filing web utility.
[PRIMARY PORT NUMBER] — Press this button to enter the primary port number to be used for HTTP access
from the other client. It is recommended that you use the default port number “80” if you are not sure about
changing this port number.
[SECONDARY PORT NUMBER] — Press this button to enter the secondary port number to be used to access
TopAccess and the e-Filing web utility. It is recommended that you use the default port number “8080” if you are not
sure about changing this port number.
When you press [PRIMARY PORT NUMBER] and [SECONDARY PORT NUMBER], the on-screen keyboard is
displayed. Enter the value using the on-screen keyboard and press [OK] to set the entry. You can also use the
digital keys on the control panel to enter numerals.
4
Continue to another network setting if required, then press [APPLY NOW].
“NETWORK INITIALIZING” is displayed at the lower left of the screen and this equipment starts initializing the
network interface card to apply the changes. This message disappears after it is finished.
To Next Page
Loading...
Need help?
General
