2.SETTING ITEMS (ADMIN)
Setting Security Functions 189
2 SETTING ITEMS (ADMIN)
Checking all data
1
Press [FULL].
The message “Are you sure ?” is displayed in the CONFIRMATION screen.
2
Press [OK].
When the integrity check is complete, the message “The process was finished successfully” will be displayed in the
CONFIRMATION screen.
y It may take a long time to complete the integrity check.
y When you press [OK] in the above screen while jobs are being processed, the message “Process cannot be
performed while Job is processing or Admin function is in progress.” will be displayed in the CAUTION
screen. In this case, press [CLOSE], and wait until processing is complete, and then perform the operation
again.
y If an error, such as illegally modified data, is detected, the service call screen will be displayed. In this case,
contact your service representative.
3
Press [OK] to reboot the equipment.
The equipment is now rebooted.
To Next Page
Loading...
Need help?
General
